Design/Operation
The UTG ultrasonic thickness gauge is an ideal
companion to the Peek Measurement range of
ultrasonic liquid flowmeters. The instrument
provides a simple and rapid means of measuring the
thickness of pipes typically found in process and
water treatment plants.
Ease
of Use
The UTG offers the ultimate in ease of operation.
Press the "ON" button, apply compound to
the area to be measured, place the probe on the
surface and read the LCD screen. To simplify field
calibrations, a test block is mounted to the front
panel and is always available for reference---thus
insuring correct operation of the instrument and
probe. The UTG features the additional facility of
10 preset calibration programs for rapid selection
of the most commonly found pipe materials.
Selection of these pre-programmed materials is
accomplished by pressing the "MAT"
button. The UTG also incorporates a
"ZERO" facility.
|
Construction
The Electronic microcircuitry of the instrument is
housed in a rigid, hermetically sealed enclosure
with integral front panel membrane. A permanently
attached cable is connected to the rugged,
stainless steel housing of the probe via a
flexible fitting which minimizes the risk of cable
breakage. The cable is further protected by an
external sheath and connects to the instrument via
an industrial standard plug. An optional probe is
available for the accurate measurement of curved
surfaces down to a radius of 0.39 inch (10mm)
Applications
In addition to being a productive tool for use
with Peak Measurement ultrasonic flowmeters, the
UTG can be used for a wide range of other
applications such as measurement of abrasion wear
and corrosion rates. It also provides a simple and
cost effective way to comply with statutory
requirements and help prevent costly unscheduled
maintenance.
|
